Liquid Rubber MetalSafe Sealant

[guarantee]

We believe everyone should have a choice to buy high quality, environmentally friendly products. We believe you should have a choice to do your own projects (most of the time you can do it better yourself than hiring someone) and save money. We believe in Free Shipping (over $75) and Free Returns. We believe in making your experience the best it can possibly be.  Please, please reach out to us with any questions.  We want to make your project a success.

[/guarantee]

[description]

Flexible Corrosion Coating

• Ultrahigh corrosion protection
• Can be applied directly over lightly rusted surfaces
• Creates a long lasting waterproof membrane
• Excellent adhesion, chemical and UV resistance
• Resists cracking, chipping, impact and abrasion
• Resistant to freeze/thaw cycles
• Withstands extreme hot and cold environments
• Easy to apply roller, brush & spray equipment
• Available in BLACK ONLY

[/description]

[coverage]

• For Flat and Ponding Surfaces:

  Apply a minimum final thickness of 1 gallon per 15 sq ft (1.4 sq/m). It should require around 4-5 heavy coats to achieve a 60-80 mil. (1.5-2.0mm) (DFT) membrane.

• For Vertical Surfaces:

  Apply a minimum final thickness of 1 gallon per 30 sq ft (2.8 sq/m). Apply 2-3 heavy coats to achieve a 30 mil. (0.76mm) (DFT) membrane.

  
  

[/coverage]

[tips]

• Apply using a 3/8 (10mm) roller, brush or appropriate paint sprayer.
• Apply to dry surface that is free of dirt, loose paint, rust, oil, grease, coal tar, silicone, or other contaminants.
• Apply when temperature is above 5°C (40°F) for black products or 10°C (50°F) and rising for colored products.
• Apply each coat in an alternate direction to the last coat to ensure even coverage.
• Apply final coat in the direction of slope for positive drainage.
• Apply next coat when dry to the touch with nothing wet underneath and is uniform in color.
• Avoid hot, direct, intense sun when applying.
• Avoid contact with solvents and solvent based cleaners, adhesives, and paints.
• Do not allow to freeze until fully cured.
• Do not combine black products with colored products.
• Do not apply in wet conditions (including fog and dew) or if rain is forecasted within 24 hours.
• Wrap brushes in plastic and refrigerate to use for next coat.
• Remove painters tape/blocking while coating is still wet.
• Seal gaps, cracks, etc. with Liquid Rubber caulking (or equivalent).
• Initial cure(set) within 48 hours or until completely dry.
• Curing depends on temperature, humidity and airflow.
• Make sure what you’re coating is at least 5 degrees above the dew point of the environment you are coating in. (See technical specs for more details)
• For best results remove existing paints/coatings and apply directly to the substrate. (Some paints and coatings will not be compatible. Loose/flaky paint may be an indication that the existing paint/coating is not well bonded and therefore your Liquid Rubber solution may fail if applied over it instead of directly to the substrate. Oil based paints, enamels, epoxies, powder coats can be difficult to bond to. Contact your Liquid Rubber technical representative for further direction.)
• It is always a good idea to apply a small test patch in an inconspicuous area to ensure adequate adhesion prior to full application.

[/tips]

[documents]

• Liquid Rubber MetalSafe Sealant Data Sheet
• Liquid Rubber MetalSafe Sealant Safety Data Sheet

[/documents]